- Out-of-Stock
MM Multisurfaces Multilak...
- Out-of-Stock
Surfaces should be sanded, clean, dry, free of dust, grease, oils and moisture. On unpainted surfaces: Sand, clean, brush, remove dust, grease, oil, saltpeter, scale, mold and other elements that can affect the anchorage and leave preferably with roughness to improve adhesion. On surfaces with old paint: Remove paint in poor condition and proceed as on unpainted surface. Apply the following preparations: On surfaces of cement mortars and derivatives, well dried and set: Apply the same product diluted with Diluent Chlororubbers 300 (Ref. 9303). See percentages. On surfaces of cement mortars in poor condition, with lime, saltpeter, etc: Remove lime and saltpeter and seal properly with SELLAFOND (Ref. 1764). On galvanized and light metals: Apply WASH PRIMER ECO.
Before applying
Application temperature: Higher than 5ºC. Support temperature:Above 8ºC. Ambient relative humidity:Less than 80%. Support humidity: Less than 6%.
How to use
Remove the contents of the container well. Apply with good air renewal, in thin, uniform and well-extended layers. Recommendations before applying Do not apply to the direct sun, or with morning dew. Add water to the pool after at least one week has elapsed since application. New pool: Allow a month to pass, once built, before painting. Percentage of application: Brush and Roller, Diluent Chlororubbers 300 (Ref. 9303), 1st hand diluted 10-15%. 2nd and 3rd to use or slightly diluted (maximum 5%)
Storage
Store in a cool place. Do not store open or started containers.
Calculate how much you need: