Stone and rough cladding for facades and prepared to make various decorative effects without risks of cracking
15 l
C. TECHNIQUES
Colors
C. APPLICATION
Suitable for protection, decoration and cladding of facades. Prepared to make various decorative effects without risks of cracking and with a rough appearance finish.
Hard and flexible finishes
Filling power.
Maximum performance.
Ease of application.
They disguise the defects of the plastering.
Weatherproof, with balanced permeability of interior moisture.
DilutionWater
T. Drying1-2hours
T. Repainted2-4hours
Performance3-5m2/L
Matte
matte white
intact 60* matte
Surface preparation
Surfaces should be clean, dry, free of dust, grease, oils, moisture, chipped and consistent. On new surfaces (cement mortar without saltpeter), apply 2 crossed layers: the 1st diluted to 5-10% water, the 2nd to use or slightly diluted (maximum 5%). On soft surfaces (mortars in poor condition) or with saltpeters, old plastic paints, lime and other paints: Remove soft, crumbly, chipped and damp parts. Also remove lime and saltpeters. Seal properly with SELLAFOND (Ref .1764) and proceed as in the previous case.
Before applying
Application temperature: Above 5ºC. Ambient relative humidity: Less than 80%. Support temperature above 8ºC.
How to use
Remove the contents of the container well. Apply in uniform layers. Apply with good air renewal. Application to brush, roller and airless gun. To realize the rough appearance and other decorative effects are necessary rollers and special tools (trowels, spatulas, etc.).
Storage
Store in a cool place. Do not store open or started containers.
Calculate how much you need:
Total area
m2
nth Layers
Necessary amount--
Suitable for protection, decoration and cladding of facades. Prepared to make various decorative effects without risks of cracking and with a rough appearance finish.
Surfaces should be clean, dry, free of dust, grease, oils, moisture, chipped and consistent. On new surfaces (cement mortar without saltpeter), apply 2 crossed layers: the 1st diluted to 5-10% water, the 2nd to use or slightly diluted (maximum 5%). On soft surfaces (mortars in poor condition) or with saltpeters, old plastic paints, lime and other paints: Remove soft, crumbly, chipped and damp parts. Also remove lime and saltpeters. Seal properly with SELLAFOND (Ref .1764) and proceed as in the previous case.
Before applying
Application temperature: Above 5ºC. Ambient relative humidity: Less than 80%. Support temperature above 8ºC.
How to use
Remove the contents of the container well. Apply in uniform layers. Apply with good air renewal. Application to brush, roller and airless gun. To realize the rough appearance and other decorative effects are necessary rollers and special tools (trowels, spatulas, etc.).
Storage
Store in a cool place. Do not store open or started containers.
Colores A Carta-15
Data sheet
Family
Facade cladding
Surface
Cement
Concrete
Facades
Feature Listed 1
HARD AND FLEXIBLE FINISHES
Feature listed 2
FILLING POWER.
Subname
Stone and rough cladding for facades and prepared to make various decorative effects without risks of cracking
Feature listed 3
MAXIMUM PERFORMANCE.
Barpicolor
No
Featured product 1
Hard and flexible finishes
Featured product 2
Filling power.
Featured product 3
Maximum performance.
Featured product 4
Ease of application.
Featured product 5
They disguise the defects of the plastering.
Featured product 6
Weatherproof, with balanced permeability of interior moisture.