• Out-of-Stock
Rough Pliobarp
search
  • Rough Pliobarp

Rough Pliobarp

Stone and rough cladding for facades and prepared to make various decorative effects without risks of cracking
15 l
C. TECHNIQUES
Colors
C. APPLICATION
Suitable for protection, decoration and cladding of facades. Prepared to make various decorative effects without risks of cracking and with a rough appearance finish.
Hard and flexible finishes
Filling power.
Maximum performance.
Ease of application.
They disguise the defects of the plastering.
Weatherproof, with balanced permeability of interior moisture.
Tiempo de secado
Dilution Water
Tiempo de secado
T. Drying 1-2hours
Tiempo de secado
T. Repainted 2-4hours
Tiempo de secado
Performance 3-5m2/L
Matte
matte white
intact 60* matte
Surface preparation

Surfaces should be clean, dry, free of dust, grease, oils, moisture, chipped and consistent. On new surfaces (cement mortar without saltpeter), apply 2 crossed layers: the 1st diluted to 5-10% water, the 2nd to use or slightly diluted (maximum 5%). On soft surfaces (mortars in poor condition) or with saltpeters, old plastic paints, lime and other paints: Remove soft, crumbly, chipped and damp parts. Also remove lime and saltpeters. Seal properly with SELLAFOND (Ref .1764) and proceed as in the previous case.

Before applying

Application temperature: Above 5ºC. Ambient relative humidity: Less than 80%. Support temperature above 8ºC.

How to use

Remove the contents of the container well. Apply in uniform layers. Apply with good air renewal. Application to brush, roller and airless gun. To realize the rough appearance and other decorative effects are necessary rollers and special tools (trowels, spatulas, etc.).

Storage

Store in a cool place. Do not store open or started containers.

Calculate how much you need:

Total area
m2
nth Layers
Necessary amount --
Cookie consent