• Out-of-Stock
Outdoor multiplast
search
  • Outdoor multiplast

Outdoor multiplast

Fine plastering in cementitious base of exterior, for the smoothing and retapado of absorbent surfaces both in thin layer and in thickness.
15 kg
5 kg
1 kg
C. TECHNIQUES
Colors
C. APPLICATION
Suitable for the recovery of cracks without movement and of a non-structural nature. Suitable for smoothing and plastering of walls to the outside (cement, painted bottoms with some absorption, brick partitions, concrete, stone ..).
Slow setting
Easy to apply
Application in thin layer and thick layer
Tiempo de secado
Dilution Knead with water at a rate of 35-40%
Tiempo de secado
T. Drying 10hours
Tiempo de secado
Performance 1 mm layer 1.65-1.80 Kg/m2
Colors
white
Surface preparation

The surface has to be clean, dry, without grease, dust, saltpeter, chipped and be consistent. Knead with water at a rate of 35-40%. Kneading must be done manually or mechanically using an electric mixer. Let the paste rest for a few minutes and then apply.

Before applying

Application temperature: Above 5ºC. Ambient relative humidity: Less than 80%

How to use

Make application proceeding to the filling of irregularities and always smoothing vertically from bottom to top. The joints are made on the contrary, from top to bottom. Those areas of façade subject to stresses (expansion joints or delimitation joints of different materials) must be reinforced with metal mesh or fiberglass (resistant to the alkalinization of cement) to avoid cracking of the plaster. The mesh will be inside plastered-mesh-plastered) and will exceed by approximately 25 cm, each side of these joints subject to stresses. The mesh light should be 1x1 cm. Sanded once dry and hard, reapply a second hand horizontally from right to left, taking the joints from left to right. After drying, sand and proceed to paint.

Storage

Store in a cool place. Do not store open or started containers.

Cookie consent