• Out-of-Stock
Pliobarp A.V.
search
  • Pliobarp A.V.

Pliobarp A.V.

Decorative coating based on acrylic resins in aqueous dispersion and pigments of great solidity.
15 l
4 l
C. TECHNIQUES
Colors
C. APPLICATION
Suitable for protection and decoration of facades, party walls and patios of lights ..., with high quality matte finish, with effective and prolonged protection in its film against the formation of lichens and algae, even in extreme atmospheric conditions.
Anti-verdin additive
Raincoat
Weatherproof
Ease of application.
Maximum performance.
Great covering power
Tiempo de secado
Dilution Water
Tiempo de secado
T. Drying 30min
Tiempo de secado
T. Repainted 2-4hours
Tiempo de secado
Performance 8-11m2/L
Matte
matte white
intact 60* matte
Surface preparation

Surfaces should be clean, dry, free of dust, grease, oils, moisture, chipped and consistent. In case of surfaces with mosses, algae, etc., clean and disinfect previously. On hard and dry surfaces and cement mortars without saltpeter: apply 2 hands: the 1st hand diluted 10% water, the second to use or slightly diluted (maximum 5%). On soft surfaces (mortars in poor condition) or with saltpeters, old plastic paints, lime and other paints: Remove soft, crumbly, chipped and damp parts. Also remove lime and saltpeters. Seal properly with SELLAFOND (Ref .1764) and proceed as in the previous case.

Before applying

Application temperature: Higher than 5ºC. Ambient relative humidity: Less than 80% Support humidity: 6%. Support temperature above 8ºC.

How to use

Remove the contents of the container well. Apply in uniform layers. Apply with good air renewal. It is not convenient to apply in full sun and with high temperatures of the support. Do not apply if there is a risk of rain and frost. Percentage of application: Brush and roller, Water The 1st hand diluted by 10%, the 2nd to use or slightly diluted (maximum 5%), Gun dilute depending on the nozzle and pressure used.

Storage

Store in a cool place. Do not store open or started containers.

Calculate how much you need:

Total area
m2
nth Layers
Necessary amount --
Cookie consent