• Out-of-Stock
RE10 fibered
search
  • RE10 fibered

RE10 fibered

Continuous waterproofing, elastic, non-asphalt coating. With microfibers to reduce contraction and expansion movements.
15 l
4 l
C. TECHNIQUES
Colors
C. APPLICATION
Suitable for waterproofing terraces, roofs, roofs, roofs, roofs and party walls. Suitable for renovation of old waterproofing, on all surfaces where it is necessary to prevent moisture and water leaks and anti-oil action. Fiberglass reinforced product
Fiberglass
Elastic and waterproof membrane shape
It penetrates deep into cracks and fissures.
Applicable in large surfaces without problem of joints.
Resistant to the alkalinity of the substrates, to the weather and to the thermal changes.
Very permeable to the interior moisture of the substrate.
Tiempo de secado
Dilution Water
Tiempo de secado
T. Drying 2-4hours
Tiempo de secado
T. Repainted 12-24hours
Tiempo de secado
Performance 4-6m2/L
Satin
satin white
red tile satin
Surface preparation

Surfaces should be clean, dry, free of dust, grease, oils, moisture, chipped and consistent. The surface must have sufficient slope for evacuation of rainwater. On hard and dry surfaces and cement mortars without saltpeter: Apply several crossed layers. The first diluted to 20% water, the rest to use or slightly diluted. Restore cracks and fissures with SAND mixture and cover with fiberglass fabric band. On soft surfaces (mortars in poor condition) or with saltpeter, lime and coatings in poor condition: Remove soft, crumbly, chipped and moisture parts. Also remove lime and saltpeters. Seal properly with SELLAFOND (Ref. 1764) and proceed as in the previous case. Recommended minimum thickness 1mm on horizontal surfaces. The effectiveness of waterproofing with ELASTICOM depends largely on the thickness applied.

Before applying

How to use

Remove the contents of the container well. Apply with good air renewal, in uniform and well-extended layers. It is advisable to apply a perimeter regatta, both ascending and descending, on the surrounding walls to integrate the waterproofing in the walls and make a more watertight space, avoiding leaks that could be between the fissures of the pavement joints with the walls or walls. Do not apply in foggy or rainy weather. It is not convenient to apply in full sun and with high temperatures of the support. Percentage of application: Brush or roller, Water 1st hand dilute approximately 20%. The others to use or slightly diluted (maximum 5%), gun depending on the nozzle and pressure. It is advisable to use wide nozzles.

Storage

Store in a cool place. Do not store open or started containers.

Cookie consent