- Out-of-Stock
MM Multisurfaces Multilak...
- Out-of-Stock
Good adhesion on different substrates. Ideal to apply on floors, plastics, PVC, etc. It can be used as an adhesion bridge for floors painted with chlororubber, subsequently painting it with epoxy or polyurethane. Suitable for concrete, PVC, plastic, glass, ceramics, etc.
Surface preparation
Surfaces should be sanded, clean, dry, free of dust, grease, oils and moisture. Clean, dry soil and well-set concrete on new floors (28 days). Residual soil moisture less than 6%. Preferably with roughness to improve adhesion. On unpainted surfaces: apply 1 - 2 hands (maximum dilution 10%) On surfaces with old paints: Remove paint in poor condition and proceed as on unpainted surfaces On surfaces with paints in good condition: Sand, clean and proceed as on unpainted surfaces.
Before applying
Do not apply with temperatures below 12ºC. Ambient relative humidity below 80%. Residual soil moisture less than 6%. Support temperature above 8ºC.
How to use
It is supplied in two containers: Component A and Component B. Component A: Epoxy Primer with White Matte Water (4 Kg or 20Kg) Component B: Catalyst K0864 (0.5 Kg or 2.5 Kg). Mechanically shake Component A until a homogeneous paste is obtained. Add Component B over Component A in its entirety. Proportion of the mixture by weight: 8 parts of "A" and 1 part of "B". Mechanically shake the mixture until a homogeneous paste is obtained again. Let stand 10 – 15 minutes. Apply with good air renewal, in thin, uniform and well-extended layers. Apply with good air renewal, in thin, uniform and well-extended layers. Apply one or more layers to recommended thickness.
Storage
Store in a cool place. Do not store open or started containers.
Calculate how much you need: